Post

K-1013 Replica update and decisions

There are two bodge wires in the board. They don’t seem to be a repair, but a factory modification and they match the schematic. It would be very easy to route proper tracks instead, but then it would not be a 1:1 reproduction…

img-description

I think I’m finally going with the proper tracks.

The pcb is progressing slowly but steadily. I’ve run into some differences between the schematic and the pcb photos that have slowed me down a bit, but I’m happy with how it’s going so far:

img-description

This post is licensed under CC BY 4.0 by the author.